Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revisionBoth sides next revision | ||
graphic:modeling [2022/05/06 17:38] – [hard surface modeling] ying | graphic:modeling [2022/05/06 18:48] – [hard surface modeling] ying | ||
---|---|---|---|
Line 28: | Line 28: | ||
* (Document > ZAppLink - cust to remember cam view) | * (Document > ZAppLink - cust to remember cam view) | ||
* dynamesh | * dynamesh | ||
- | | + | * (Tool > Geometry > DynaMesh : start with 128 as resolution, it decide the vtx dense of generated mesh) |
- | * decimation | + | |
+ | * hPolish brush (for hard surface, it smooth but keep overall hard surface transitions) | ||
+ | * TrimDynamic (it is like hPolish, but edge is a bit smooth) | ||
+ | * TrimAdaptive (it use start point surface normal, and push the normal continuous and extending surface trend ) | ||
+ | * Move (like soft selection move in maya) | ||
+ | * DamStandard (cut into deep) | ||
+ | * Layer (like adding a new layer of clay, alt = remove a layer of clay from model) | ||
+ | * -- | ||
+ | * Tool > Deformation > Inflate | ||
+ | * decimation | ||
+ | * ZPlugin > Decimation Mater | ||
+ | * pre-process current, and choose 20% | ||
+ | * export with (no Grp) | ||
* retopo with quad draw | * retopo with quad draw | ||
+ | * make zbrush obj as live mesh | ||
+ | * ctrl+shift+q: | ||
+ | * +ctrl to insert edge loop | ||
+ | * make edge loops | ||
cmds for modeling related <code python> | cmds for modeling related <code python> |